Tamko 19" SELVEDGE EDGE User Manual download pdf

Application Instructions for

TAMKO

19" SELVEDGE EDGE

ROLL ROOFING

This product is NOT to be used on slopes

less than 1 in. per horizontal foot.

ROOF DECK – Roof deck must be smooth, dry

and free from warped surfaces. It is recommended

that metal drip edges be installed at eaves and

rakes.

UNROLL BEFORE APPLYING – Rooﬁng should

be unrolled and allowed to lie ﬂat in warm sunlight

for some time in advance of application. This

allows the material to relax, thereby minimizing

the possibility of buckles and surface unevenness.

THE SHEET SHOULD BE CUT IN 12 ft. to 18 ft.

LENGTHS.

TEMPERATURE

– Rooﬁng must not be applied

when air temperature is below 50°F unless

proper precautions have been taken to allow for

application of the material.

ADHESIVE – Use lap cement meeting ASTM D

3019.

APPLICATION

– Sheets are to be applied

horizontally from the eave to the ridge.

Begin by applying starter strips to the eave.

Remove the 17 in. granule-surface portion from a

sheet of selvedge roll rooﬁng. Place the remaining

19 in. portion parallel to eave so that it overhangs

the drip edge 1/4 in. to 3/8 in. at both the eaves

and rakes. Fasten it to deck with 2 rows of nails

in the selvedge portion. Locate the ﬁrst row 5

in. in from the side edge and the second row 9

in. in from the ﬁrst with the nails spaced 12 in.

on center, slightly staggering them in each row.

Cover the entire starter strip with a thin layer of

cold application cement. Place full width sheet

over it, fastening with 2 rows of nails in selvedge

portion as shown in diagram below. Continue each

succeeding course, in the same manner, varying

the 12 ft. to 18 ft. sheet lengths to ensure that top

laps do not fall next to each other.

WARNING

All cement is to be applied in thin, smooth, even

layers. Excessive use of cement will cause

blistering of this product. TAMKO Rooﬁng

Products, Inc. will assume NO responsibility

for the blistering.

Additional illustrations and installation details are

available in the Asphalt Rooﬁng Manufacturers

Association Booklet, “Residential Asphalt Rooﬁng

Manual”.

Position all laps so the upper sheet overlies the lower one,

thereby carrying drainage over the joint rather than into it.

Selvedge edge roll rooﬁng may also be applied parallel to

the rakes.

www.tamko.com

TAMKO

is a Registered Trademark

of TAMKO Rooﬁng Products, Inc.

1 2

19" SELVEDGE EDGE 1

Summary of Contents

Page 1 - 19" SELVEDGE EDGE

Application Instructions forTAMKO® 19" SELVEDGE EDGEROLL ROOFINGThis product is NOT to be used on slopes less than 1 in. per horizontal foot.ROOF

Page 2

Comments to this Manuals

No comments

Tamko 19" SELVEDGE EDGE User Manual

Browse online or download User Manual for For Home Tamko 19" SELVEDGE EDGE. TAMKO 19" SELVEDGE EDGE User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For Home Tamko 19" SELVEDGE EDGE