INSTRUCTION MANUALWhen to use:page up to 6 inches = 1 inchpage up to 12 inches = 1.5 inchpage up to 18 inches = 2 inchpage over 18 inches = 2.5 inch1
4.25" MIN.4.25" MIN. INSTALLATION STEPS:1 Assemble the concrete surface plate to the bottom of the post mount member as shown using fou
POST MOUNT INSTALLATION CONCRETE APPLICATION (continued)Fig. 4Fig. 5121314153/8" STAINLESS STEEL HEX NUT3/8" STAINLESS STEEL WASHER3/8"
It is the responsibility of the installer to meet all building code and safety requirements and to obtain all required building permits. For Marquee R
BEFORE YOU BEGIN:IMPORTANT PRODUCT SAFETY AND PRE-INSTALLATION INFORMATIONFAILURE TO FOLLOW THESE INSTRUCTIONS MAY LEAD TO AN UNSAFELY INSTALLED PRODU
2FIGURE 1FIGURE 2 INSTALLATION STEPS:1 Install and prepare posts or other mounting surfaces for Marquee Railing® installation. Ensure mounting s
FIGURE 5FIGURE 6FIGURE 7FIGURE 8Attach the crush block included with the Marquee Rail Kit on the underside of the bottom rail using the screw provide
FIGURE 1FIGURE 2Fig. 1Fig. 24123This installation is limited to use with nominal 4" x 4" wood posts only. Not for use with wood/composite or
INSTALLATION STEPS:1 Install and prepare posts or other mounting surfaces for Marquee Railing® installation. Ensure mounting surfaces are level
101112FIGURE 5B4 Set the bottom rail to the side. Position the bracket at marked location and secure using two of the screws provided in the Marq
Marquee™ Wood/Composite Post Mount Kit 5" x 5" x 38" for use with all Marquee 6' and 8' Railing Kits at 36" Rail Hei
Marquee™ Concrete Post Mount Kit 5" x 5" x 38" for use with all Marquee 6' Railing Kits in 36" Rail Heights Marquee Conc
Comments to this Manuals