Tamko Xtractor Vent User Manual download pdf

STEP 1. Cut a slot in plywood along the roof ridge 1 1/2" wide

(3/4" on each side). If ridge beam is present, cut slot

3/4" wide on each side of ridge beam. Allow for a

closed area of sheathing 12" at both ends of ridge.

STEP 2. Place beginning female end vent 1" in from gable end

and use center line for proper alignment along peak.

Fasten using at least two nails at each end and in

middle of roll in nail line area (1 3/4" minimum nail

length) spacing approximately every 12 inches. More

nails may be required on steeper slopes to seat

properly. Continue installing additional rolls as

needed along ridge sliding female end over male end,

aligning using centering line. When reaching the

other end, cut vent roll to 1" from gable end and nail

in place. End plugs are provided every 6" on the

underside of the product.

STEP 3. Place ﬁrst cap shingle over vent so that it overhangs

at least 1" over end of vent roll. Install with 1 3/4"

nails provided in nail line area as you work your way

down the roof. Cut last cap shingle so that it over

hangs vent 1" at other gable end.

Central District 220 West 4th St., Joplin, MO 64801 800-641-4691

Northeast District 4500 Tamko Dr., Frederick, MD 21701 800-368-2055

Southeast District 2300 35th St., Tuscaloosa, AL 35401 800-228-2656

Southwest District 7910 S. Central Exp., Dallas, TX 75216 800-443-1834

Western District 5300 East 43rd Ave., Denver, CO 80216 800-530-8868

Application Instructions for

XTRACTOR VENT

XLP TURBO

Continuous Ridge Vent

800-641-4691

Visit Our Web Site at

tamko.com

STEP 1. Cut a slot in plywood along the roof ridge 1 1/2" wide (3/4" on each side). If ridge beam is present, cut slot 3/4" wid

Related models: XLP Turbo

No comments